Engineering & Calculation Disclaimer
Important Information for Consulting Engineers & Operators
1. Professional Engineering Verification
Boiler feedwater systems are safety-critical industrial installations operating under high pressures (ASME Boiler & Pressure Vessel Code Section I). No physical pump procurement, motor sizing, or pipe installation should take place based solely on automated web outputs.
Final equipment selection must be reviewed, recalculated, and approved by a qualified Professional Engineer (PE) who takes responsibility for the specific site conditions, local code requirements, and actual manufacturer pump curves (API 610 / ISO 9906).
2. Thermodynamic Approximations
Water density, saturation pressure, and viscosity equations utilized within this calculator are based on IAPWS-IF97 standards or high-accuracy polynomial approximations valid within 0°C to 200°C. While highly accurate, actual site conditions (fluid purity, chemical treatment additives, dissolved gases) may alter specific physical properties slightly.
3. No Warranties
The Service is provided "AS IS" and "AS AVAILABLE" without warranties of any kind, whether express or implied. JokesOf does not warrant that the results obtained from the use of the calculator will be error-free or uninterrupted.
Recommended Next Steps for Engineers
- Export calculation report from our Calculator Page.
- Obtain certified pump head-capacity (H-Q) curves from pump manufacturers (e.g., KSB, Sulzer, Grundfos, Flowserve).
- Perform transient thermal stress and water hammer (surge) calculations for high-pressure feed lines.
- Engage a licensed Professional Engineer (PE) for final verification and code stamp.